Some Early Fun with Spools

Fun with Spools Gallery Added!

More from the backlog.

I have just add a gallery called Fun with Spools.  So, for most desktop 3D printing, the plastic you use comes in spools of plastic filament.  This gallery is for whenever I play around with the spools themselves.

There is not much there right now, just a few comparisons between spools.  But I expect more fun spooliness in the future. :D

An Early Comparison

I wanted to know how much of the Ultimaker Silver PLA I had used, so I compared it with the ColorFabb Ultramarine Blue PLA that I had not used yet. :)

Printed a Lot, Not Much Used

Despite having printed quite a few things in the silver, I had not used much filament at that time.  ...  Now the silver is almost gone! :)

Height Comparison Fail

I tried to capture a height of filament vs spool wall comparison, but I failed. :(

Well, It Half Worked

Well, I was able to get the silver's height vs spool wall, but I did not also get the blue for comparison. :(  Oh well.  Good enough. :)